Clean the Surface

• Start by cleaning the material surface with alcohol to remove any dirt or oils.
• Make sure the surface is completely dry before proceeding.

Apply the Spray

• Shake the bottle well before using to ensure all the contents are properly mixed.
• Hold the bottle at a 45° angle, about 6-8 inches away from the surface.
• Use a left-to-right motion to apply an even, thin coat. Apply just enough until the surface is no longer see-through.

Start engraving:

• Adjust your laser settings based on the material you’re working with.
• Please check the general recommended settings by choosing the laser machine you are currently using.

Removing the residue:

• There’s no waiting time required! Once you're done lasering, rinse the surface under tap water or simply wipe it with a wet cloth. That’s it—enjoy your permanent, high-quality mark on your finished product!

Clean the Surface

• Start by cleaning the material surface with alcohol to remove any dirt or oils.
• Make sure the surface is completely dry before proceeding.

Mix the Powder with Denatured Alcohol or any Isopropyl Alcohol

• Mix denatured alcohol and powder at a 1:1 ratio by weight. For example, 10 grams of powder and 10 grams of alcohol make a 1:1 ratio.
• For bulk powders, please weigh the product in a separate beaker to create your desired ratio of powder and alcohol mixture.

Apply the prepared laser ink powder

• Using the brush, apply in a left-to-right motion to create a thin, even coat. Use just enough to ensure the surface is completely no longer see-through.

Start engraving:

• Adjust your laser settings based on the material you’re working with.
• Please check the general recommended settings by choosing the laser machine you are currently using.

Removing the residue:

• There’s no waiting time required! Once you're done lasering, rinse the surface under tap water or simply wipe it with a wet cloth. That’s it—enjoy your permanent, high-quality mark on your finished product!

Clean the Surface

• Start by cleaning the material surface with alcohol to remove any dirt or oils.
• Make sure the surface is completely dry before proceeding.

Mix the Liquid-Ready powder with Denatured Alcohol or any Isopropyl Alcohol

• The bottle has markings on the side of the label to guide you in adding denatured alcohol for both brush and spray applications. While both methods work, spray application is recommended, ideally using a Preval spray system.

Apply the prepared laser ink powder

• Using the brush, apply in a left-to-right motion to create a thin, even coat. Use just enough to ensure the surface is completely no longer see-through.

Start engraving:

• Adjust your laser settings based on the material you’re working with.
• Please check the general recommended settings by choosing the laser machine you are currently using.

Removing the residue:

• There’s no waiting time required! Once you're done lasering, rinse the surface under tap water or simply wipe it with a wet cloth. That’s it—enjoy your permanent, high-quality mark on your finished product!